B1236
Low Severity (Level 1)Window Feedback Loss of Signal
B1236 usually means window Feedback Loss of Signal.
Can you still drive with B1236?
✅Safe to drive — this is an informational or minor issue. Schedule diagnosis at your convenience.
Typical repair cost: $100 – $500
Severity Level 1 — Low
This code indicates a minor issue that is unlikely to cause immediate driveability problems. You can typically continue driving but should have the vehicle inspected at your earliest convenience.
Common Symptoms
- Power window won't go up or down — stuck in current position
- Window moves slowly or only works from one switch
- Diagnostic trouble code (DTC) stored in module memory
- Fault may be intermittent — code may clear itself and reappear
- Reduced vehicle functionality related to the power window system
Possible Causes
- Faulty window motor/regulator — most common cause, test before replacing
- Damaged or corroded wiring/connector in the power window system circuit
- Blown fuse or faulty relay for the power window system
- Poor ground connection — check and clean all related ground points
- Control module fault — rare but possible, only consider after ruling out simpler causes
- Window regulator mechanical failure — cable snapped or pulley broken, motor runs but glass doesn't move
Common Fixes
- Scan vehicle with a professional-grade OBD2 scanner to read all stored codes and freeze frame data — note the conditions when the code set ($47-103 at shop, free at auto parts store for basic scan)
- Visually inspect the power window system wiring harness and connectors — look for chafed wires, melted insulation, green corrosion, loose pins, or rodent damage (often free to check yourself, $54 diagnostic fee at shop)
- Inspect the wiring boot where it passes from the body into the door — this is the #1 failure point. Peel back the rubber boot and check for broken/cracked wires ($0 DIY inspection)
- Replace window motor/regulator if testing confirms it has failed — use OEM quality, avoid the cheapest no-name aftermarket parts that fail in a year ($100-500)
- Check and replace any blown fuses in the power window system fuse circuit — if fuse blows again, there's still a short that needs to be found ($1-10 for fuses)
Estimated Repair Cost
These are estimated costs based on generic repair data. Actual costs may vary depending on your vehicle, location, and labor rates.
Frequently Asked Questions
What does B1236 mean?
B1236 stands for "Window Feedback Loss of Signal". B1236 usually means window Feedback Loss of Signal.
Can you drive with B1236?
Safe to drive — this is an informational or minor issue. Schedule diagnosis at your convenience.
How much does it cost to fix B1236?
Repair costs for B1236 typically range from $100 to $500, depending on your vehicle make, model, and local labor rates. Common fixes include: Scan vehicle with a professional-grade OBD2 scanner to read all stored codes and freeze frame data — note the conditions when the code set ($47-103 at shop, free at auto parts store for basic scan); Visually inspect the power window system wiring harness and connectors — look for chafed wires, melted insulation, green corrosion, loose pins, or rodent damage (often free to check yourself, $54 diagnostic fee at shop); Inspect the wiring boot where it passes from the body into the door — this is the #1 failure point. Peel back the rubber boot and check for broken/cracked wires ($0 DIY inspection).
Will B1236 clear itself?
Related Repair Costs
Explore Repair Costs
Related OBD-II Codes
These codes are in the same range as B1236 and often share similar causes and fixes.
Worried about repair costs?
Get transparent estimates and verify your mechanic's quote before authorizing repairs.
Related Discussions
See what other car owners are saying about this code and related repairs.
View B1236 discussions in the community