B1310
Low Severity (Level 1)Power Door Unlock Circuit Failure
B1310 usually means power Door Unlock Circuit Failure.
Can you still drive with B1310?
✅Safe to drive — this is an informational or minor issue. Schedule diagnosis at your convenience.
Typical repair cost: $80 – $500
Severity Level 1 — Low
This code indicates a minor issue that is unlikely to cause immediate driveability problems. You can typically continue driving but should have the vehicle inspected at your earliest convenience.
Common Symptoms
- Power door locks not functioning as expected
- Door locks cycling (locking/unlocking) on their own while driving
- Warning light or message on dashboard related to the power door lock/latch system
- Diagnostic trouble code (DTC) stored in module memory
Possible Causes
- Failed door lock actuator — internal fault from age, heat cycling, and vibration
- Damaged wiring or corroded connector in the power door lock/latch system circuit
- Blown fuse for the power door lock/latch system circuit — check before replacing components
- Faulty control module driving the door lock actuator
- Loose or corroded ground point shared by the power door lock/latch system
- Broken wire in the door jamb wiring boot — harness flexes every time the door opens, eventually wires break inside the rubber boot
Common Fixes
- Scan vehicle with a professional-grade OBD2 scanner to read all stored codes and freeze frame data — note the conditions when the code set ($16-149 at shop, free at auto parts store for basic scan)
- Visually inspect the power door lock/latch system wiring harness and connectors — look for chafed wires, melted insulation, green corrosion, loose pins, or rodent damage (often free to check yourself, $117 diagnostic fee at shop)
- Inspect the wiring boot where it passes from the body into the door — this is the #1 failure point. Peel back the rubber boot and check for broken/cracked wires ($0 DIY inspection)
- Replace door lock actuator if testing confirms it has failed — use OEM quality, avoid the cheapest no-name aftermarket parts that fail in a year ($80-500)
- Check and replace any blown fuses in the power door lock/latch system fuse circuit — if fuse blows again, there's still a short that needs to be found ($5-18 for fuses)
Estimated Repair Cost
These are estimated costs based on generic repair data. Actual costs may vary depending on your vehicle, location, and labor rates.
Frequently Asked Questions
What does B1310 mean?
B1310 stands for "Power Door Unlock Circuit Failure". B1310 usually means power Door Unlock Circuit Failure.
Can you drive with B1310?
Safe to drive — this is an informational or minor issue. Schedule diagnosis at your convenience.
How much does it cost to fix B1310?
Repair costs for B1310 typically range from $80 to $500, depending on your vehicle make, model, and local labor rates. Common fixes include: Scan vehicle with a professional-grade OBD2 scanner to read all stored codes and freeze frame data — note the conditions when the code set ($16-149 at shop, free at auto parts store for basic scan); Visually inspect the power door lock/latch system wiring harness and connectors — look for chafed wires, melted insulation, green corrosion, loose pins, or rodent damage (often free to check yourself, $117 diagnostic fee at shop); Inspect the wiring boot where it passes from the body into the door — this is the #1 failure point. Peel back the rubber boot and check for broken/cracked wires ($0 DIY inspection).
Will B1310 clear itself?
Explore Repair Costs
Related OBD-II Codes
These codes are in the same range as B1310 and often share similar causes and fixes.
Worried about repair costs?
Get transparent estimates and verify your mechanic's quote before authorizing repairs.
Related Discussions
See what other car owners are saying about this code and related repairs.
View B1310 discussions in the community