B1408
Low Severity (Level 1)Driver Power Window Up Circuit Short To Battery
B1408 usually means driver Power Window Up Circuit Short To Battery.
Can you still drive with B1408?
✅Safe to drive — this is an informational or minor issue. Schedule diagnosis at your convenience.
Typical repair cost: $120 – $600
Severity Level 1 — Low
This code indicates a minor issue that is unlikely to cause immediate driveability problems. You can typically continue driving but should have the vehicle inspected at your earliest convenience.
Common Symptoms
- Battery draining overnight or when vehicle is parked
- Power window won't go up or down — stuck in current position
- Power windows staying on or functioning when they shouldn't (powered continuously)
- Excessive current draw on the power window system circuit (fuse may blow repeatedly)
Possible Causes
- Damaged wiring in the power window system harness shorted to a 12V power source — wiring insulation chafed through from rubbing against metal body panels
- Water intrusion or corrosion in power window system electrical connector causing internal short to battery voltage
- Failed window motor/regulator — internal short to power within the component
- Aftermarket accessory installation tapped into the wrong circuit, back-feeding 12V
- Window regulator mechanical failure — cable snapped or pulley broken, motor runs but glass doesn't move
Common Fixes
- Scan vehicle with a professional-grade OBD2 scanner to read all stored codes and freeze frame data — note the conditions when the code set ($43-146 at shop, free at auto parts store for basic scan)
- Visually inspect the power window system wiring harness and connectors — look for chafed wires, melted insulation, green corrosion, loose pins, or rodent damage (often free to check yourself, $102 diagnostic fee at shop)
- Repair or replace damaged section of wiring harness where short is located — solder and heat-shrink all connections, don't use crimp connectors on critical circuits ($134-394 depending on accessibility)
- If window motor/regulator is internally shorted, replace with a quality OEM or OEM-equivalent aftermarket unit ($100-500)
- Clean all ground points related to the power window system — remove bolt, sand contact surface to bare metal, apply dielectric grease, and torque to spec ($65-198 at shop)
Estimated Repair Cost
These are estimated costs based on generic repair data. Actual costs may vary depending on your vehicle, location, and labor rates.
Frequently Asked Questions
What does B1408 mean?
B1408 stands for "Driver Power Window Up Circuit Short To Battery". B1408 usually means driver Power Window Up Circuit Short To Battery.
Can you drive with B1408?
Safe to drive — this is an informational or minor issue. Schedule diagnosis at your convenience.
How much does it cost to fix B1408?
Repair costs for B1408 typically range from $120 to $600, depending on your vehicle make, model, and local labor rates. Common fixes include: Scan vehicle with a professional-grade OBD2 scanner to read all stored codes and freeze frame data — note the conditions when the code set ($43-146 at shop, free at auto parts store for basic scan); Visually inspect the power window system wiring harness and connectors — look for chafed wires, melted insulation, green corrosion, loose pins, or rodent damage (often free to check yourself, $102 diagnostic fee at shop); Repair or replace damaged section of wiring harness where short is located — solder and heat-shrink all connections, don't use crimp connectors on critical circuits ($134-394 depending on accessibility).
Will B1408 clear itself?
Related Repair Costs
Explore Repair Costs
Related OBD-II Codes
These codes are in the same range as B1408 and often share similar causes and fixes.
Worried about repair costs?
Get transparent estimates and verify your mechanic's quote before authorizing repairs.
Related Discussions
See what other car owners are saying about this code and related repairs.
View B1408 discussions in the community