B1624
Moderate Severity (Level 3)Lamp Keypad Output Open Circuit
B1624 usually means lamp Keypad Output Open Circuit.
Can you still drive with B1624?
⚠️Short-distance driving is usually OK, but have this diagnosed within a week to prevent further damage.
Typical repair cost: $110 – $900
Severity Level 3 — Moderate
This code indicates a moderate issue that may affect vehicle performance and fuel economy. Continued driving is possible in most cases, but prompt diagnosis and repair are recommended to prevent further damage.
Common Symptoms
- Key/ignition working intermittently, then stopping completely
- Alarm going off randomly or not arming
- Engine cranks but won't start — immobilizer preventing start
- Infinite resistance in the key/immobilizer circuit — broken wire or disconnected connector
Possible Causes
- Broken wire or connector pin in the key/immobilizer system harness — common at flex points like door jambs or where wiring moves
- Disconnected or loose electrical connector — may have been bumped during other repairs
- Failed immobilizer antenna — internal open circuit from age, heat cycling, or vibration
- Corrosion completely severing a wire or connector terminal — green crust on copper wiring
- Wiring harness damage from rodent chewing — look for nesting material near the engine or under dash
Common Fixes
- Scan vehicle with a professional-grade OBD2 scanner to read all stored codes and freeze frame data — note the conditions when the code set ($1-103 at shop, free at auto parts store for basic scan)
- Visually inspect the key/immobilizer system wiring harness and connectors — look for chafed wires, melted insulation, green corrosion, loose pins, or rodent damage (often free to check yourself, $141 diagnostic fee at shop)
- Trace the key/immobilizer system wiring from connector to connector with a multimeter set to continuity/resistance mode — find and repair the break in the circuit ($130-480 labor for diagnosis and repair)
- Check and reseat all connectors in the key/immobilizer system circuit — disconnect, inspect pins, clean with electrical contact cleaner, apply dielectric grease, and reconnect firmly ($19 DIY or $58 shop minimum)
- If immobilizer antenna has failed internally (open circuit inside), replace it — don't try to repair sealed components ($100-800)
Estimated Repair Cost
These are estimated costs based on generic repair data. Actual costs may vary depending on your vehicle, location, and labor rates.
Frequently Asked Questions
What does B1624 mean?
B1624 stands for "Lamp Keypad Output Open Circuit". B1624 usually means lamp Keypad Output Open Circuit.
Can you drive with B1624?
Short-distance driving is usually OK, but have this diagnosed within a week to prevent further damage.
How much does it cost to fix B1624?
Repair costs for B1624 typically range from $110 to $900, depending on your vehicle make, model, and local labor rates. Common fixes include: Scan vehicle with a professional-grade OBD2 scanner to read all stored codes and freeze frame data — note the conditions when the code set ($1-103 at shop, free at auto parts store for basic scan); Visually inspect the key/immobilizer system wiring harness and connectors — look for chafed wires, melted insulation, green corrosion, loose pins, or rodent damage (often free to check yourself, $141 diagnostic fee at shop); Trace the key/immobilizer system wiring from connector to connector with a multimeter set to continuity/resistance mode — find and repair the break in the circuit ($130-480 labor for diagnosis and repair).
Will B1624 clear itself?
Explore Repair Costs
Related OBD-II Codes
These codes are in the same range as B1624 and often share similar causes and fixes.
Worried about repair costs?
Get transparent estimates and verify your mechanic's quote before authorizing repairs.
Related Discussions
See what other car owners are saying about this code and related repairs.
View B1624 discussions in the community