B1675
Low Severity (Level 1)Seat Driver Occupied Input Circuit Short To Ground
B1675 usually means seat Driver Occupied Input Circuit Short To Ground.
Can you still drive with B1675?
✅Safe to drive — this is an informational or minor issue. Schedule diagnosis at your convenience.
Typical repair cost: $120 – $1000
Severity Level 1 — Low
This code indicates a minor issue that is unlikely to cause immediate driveability problems. You can typically continue driving but should have the vehicle inspected at your earliest convenience.
Common Symptoms
- Power seat won't move in one or more directions
- Seat memory settings not saving or recalling correctly
- Power seats not working or completely dead
- Zero voltage on the power seat system circuit — short pulls signal to ground
Possible Causes
- Chafed or pinched wire in the power seat system circuit — wire insulation worn through, copper touching vehicle chassis/ground
- Failed seat motor/module with internal short to ground — most common when the component gets wet or overheats
- Corrosion in the electrical connector allowing current to leak to the connector shell/ground
- Damaged wiring harness where it passes through a body panel grommet or near a sharp metal edge
Common Fixes
- Scan vehicle with a professional-grade OBD2 scanner to read all stored codes and freeze frame data — note the conditions when the code set ($11-108 at shop, free at auto parts store for basic scan)
- Visually inspect the power seat system wiring harness and connectors — look for chafed wires, melted insulation, green corrosion, loose pins, or rodent damage (often free to check yourself, $95 diagnostic fee at shop)
- Repair or replace damaged section of wiring harness where short is located — solder and heat-shrink all connections, don't use crimp connectors on critical circuits ($190-245 depending on accessibility)
- If seat motor/module is internally shorted, replace with a quality OEM or OEM-equivalent aftermarket unit ($100-800)
- Clean all ground points related to the power seat system — remove bolt, sand contact surface to bare metal, apply dielectric grease, and torque to spec ($34-151 at shop)
Estimated Repair Cost
These are estimated costs based on generic repair data. Actual costs may vary depending on your vehicle, location, and labor rates.
Frequently Asked Questions
What does B1675 mean?
B1675 stands for "Seat Driver Occupied Input Circuit Short To Ground". B1675 usually means seat Driver Occupied Input Circuit Short To Ground.
Can you drive with B1675?
Safe to drive — this is an informational or minor issue. Schedule diagnosis at your convenience.
How much does it cost to fix B1675?
Repair costs for B1675 typically range from $120 to $1000, depending on your vehicle make, model, and local labor rates. Common fixes include: Scan vehicle with a professional-grade OBD2 scanner to read all stored codes and freeze frame data — note the conditions when the code set ($11-108 at shop, free at auto parts store for basic scan); Visually inspect the power seat system wiring harness and connectors — look for chafed wires, melted insulation, green corrosion, loose pins, or rodent damage (often free to check yourself, $95 diagnostic fee at shop); Repair or replace damaged section of wiring harness where short is located — solder and heat-shrink all connections, don't use crimp connectors on critical circuits ($190-245 depending on accessibility).
Will B1675 clear itself?
Explore Repair Costs
Related OBD-II Codes
These codes are in the same range as B1675 and often share similar causes and fixes.
Worried about repair costs?
Get transparent estimates and verify your mechanic's quote before authorizing repairs.
Related Discussions
See what other car owners are saying about this code and related repairs.
View B1675 discussions in the community