B1756
Low Severity (Level 1)Hazard Flash Output Circuit Short To Ground
B1756 usually means hazard Flash Output Circuit Short To Ground.
Can you still drive with B1756?
✅Safe to drive — this is an informational or minor issue. Schedule diagnosis at your convenience.
Typical repair cost: $10 – $200
Severity Level 1 — Low
This code indicates a minor issue that is unlikely to cause immediate driveability problems. You can typically continue driving but should have the vehicle inspected at your earliest convenience.
Common Symptoms
- Turn signals not working or completely dead
- Turn signals blowing fuses when activated
- Zero voltage on the turn signal/hazard system circuit — short pulls signal to ground
- Fault may be intermittent — code may clear itself and reappear
- Reduced vehicle functionality related to the turn signal/hazard system
Possible Causes
- Chafed or pinched wire in the turn signal/hazard system circuit — wire insulation worn through, copper touching vehicle chassis/ground
- Failed turn signal flasher with internal short to ground — most common when the component gets wet or overheats
- Corrosion in the electrical connector allowing current to leak to the connector shell/ground
- Damaged wiring harness where it passes through a body panel grommet or near a sharp metal edge
Common Fixes
- Scan vehicle with a professional-grade OBD2 scanner to read all stored codes and freeze frame data — note the conditions when the code set ($40-99 at shop, free at auto parts store for basic scan)
- Visually inspect the turn signal/hazard system wiring harness and connectors — look for chafed wires, melted insulation, green corrosion, loose pins, or rodent damage (often free to check yourself, $67 diagnostic fee at shop)
- Repair or replace damaged section of wiring harness where short is located — solder and heat-shrink all connections, don't use crimp connectors on critical circuits ($197-200 depending on accessibility)
- If turn signal flasher is internally shorted, replace with a quality OEM or OEM-equivalent aftermarket unit ($10-200)
- Clean all ground points related to the turn signal/hazard system — remove bolt, sand contact surface to bare metal, apply dielectric grease, and torque to spec ($35-124 at shop)
Estimated Repair Cost
These are estimated costs based on generic repair data. Actual costs may vary depending on your vehicle, location, and labor rates.
Frequently Asked Questions
What does B1756 mean?
B1756 stands for "Hazard Flash Output Circuit Short To Ground". B1756 usually means hazard Flash Output Circuit Short To Ground.
Can you drive with B1756?
Safe to drive — this is an informational or minor issue. Schedule diagnosis at your convenience.
How much does it cost to fix B1756?
Repair costs for B1756 typically range from $10 to $200, depending on your vehicle make, model, and local labor rates. Common fixes include: Scan vehicle with a professional-grade OBD2 scanner to read all stored codes and freeze frame data — note the conditions when the code set ($40-99 at shop, free at auto parts store for basic scan); Visually inspect the turn signal/hazard system wiring harness and connectors — look for chafed wires, melted insulation, green corrosion, loose pins, or rodent damage (often free to check yourself, $67 diagnostic fee at shop); Repair or replace damaged section of wiring harness where short is located — solder and heat-shrink all connections, don't use crimp connectors on critical circuits ($197-200 depending on accessibility).
Will B1756 clear itself?
Explore Repair Costs
Related OBD-II Codes
These codes are in the same range as B1756 and often share similar causes and fixes.
Worried about repair costs?
Get transparent estimates and verify your mechanic's quote before authorizing repairs.
Related Discussions
See what other car owners are saying about this code and related repairs.
View B1756 discussions in the community