B2145
Serious Severity (Level 4)NVM RF HR Failure
B2145 usually means nVM RF HR Failure.
Can you still drive with B2145?
⚠️Limited driving — get to a repair shop within 1–2 days. Avoid long trips and highway speeds.
Typical repair cost: $150 – $2000
Severity Level 4 — Serious
This code indicates a serious issue that can cause noticeable driveability problems and potential engine damage if not addressed. The vehicle should be taken to a mechanic as soon as possible. Extended driving is not recommended.
Common Symptoms
- Control module not functioning as expected
- Warning light or message on dashboard related to the control module memory system
- Check Engine Light illuminated
- Diagnostic trouble code (DTC) stored in module memory
Possible Causes
- Failed control module (PCM/BCM) — internal fault from age, heat cycling, and vibration
- Damaged wiring or corroded connector in the control module memory system circuit
- Blown fuse for the control module memory system circuit — check before replacing components
- Faulty control module/PCM
- Loose or corroded ground point shared by the control module memory system
Common Fixes
- Scan vehicle with a professional-grade OBD2 scanner to read all stored codes and freeze frame data — note the conditions when the code set ($42-124 at shop, free at auto parts store for basic scan)
- Visually inspect the control module memory system wiring harness and connectors — look for chafed wires, melted insulation, green corrosion, loose pins, or rodent damage (often free to check yourself, $68 diagnostic fee at shop)
- Replace control module (PCM/BCM) if testing confirms it has failed — use OEM quality, avoid the cheapest no-name aftermarket parts that fail in a year ($150-2000)
- Check and replace any blown fuses in the control module memory system fuse circuit — if fuse blows again, there's still a short that needs to be found ($2-16 for fuses)
- Perform a wiggle test on the control module memory system wiring harness while monitoring live data — see if the fault returns when you move the harness at different points ($0-148 diagnostic labor)
Estimated Repair Cost
These are estimated costs based on generic repair data. Actual costs may vary depending on your vehicle, location, and labor rates.
Frequently Asked Questions
What does B2145 mean?
B2145 stands for "NVM RF HR Failure". B2145 usually means nVM RF HR Failure.
Can you drive with B2145?
Limited driving — get to a repair shop within 1–2 days. Avoid long trips and highway speeds.
How much does it cost to fix B2145?
Repair costs for B2145 typically range from $150 to $2000, depending on your vehicle make, model, and local labor rates. Common fixes include: Scan vehicle with a professional-grade OBD2 scanner to read all stored codes and freeze frame data — note the conditions when the code set ($42-124 at shop, free at auto parts store for basic scan); Visually inspect the control module memory system wiring harness and connectors — look for chafed wires, melted insulation, green corrosion, loose pins, or rodent damage (often free to check yourself, $68 diagnostic fee at shop); Replace control module (PCM/BCM) if testing confirms it has failed — use OEM quality, avoid the cheapest no-name aftermarket parts that fail in a year ($150-2000).
Will B2145 clear itself?
B2145 will not clear itself. This code indicates a serious issue that requires immediate attention. The check engine light will remain on until the problem is properly diagnosed and repaired.
Explore Repair Costs
Related OBD-II Codes
These codes are in the same range as B2145 and often share similar causes and fixes.
Worried about repair costs?
Get transparent estimates and verify your mechanic's quote before authorizing repairs.
Related Discussions
See what other car owners are saying about this code and related repairs.
View B2145 discussions in the community