B2195
Low Severity (Level 1)Driver Window Up / Down Power Circuit Short to Ground
B2195 usually means driver Window Up / Down Power Circuit Short to Ground.
Can you still drive with B2195?
✅Safe to drive — this is an informational or minor issue. Schedule diagnosis at your convenience.
Typical repair cost: $120 – $600
Severity Level 1 — Low
This code indicates a minor issue that is unlikely to cause immediate driveability problems. You can typically continue driving but should have the vehicle inspected at your earliest convenience.
Common Symptoms
- Power window won't go up or down — stuck in current position
- Power windows blowing fuses when activated
- Window moves slowly or only works from one switch
- Zero voltage on the power window system circuit — short pulls signal to ground
Possible Causes
- Chafed or pinched wire in the power window system circuit — wire insulation worn through, copper touching vehicle chassis/ground
- Failed window motor/regulator with internal short to ground — most common when the component gets wet or overheats
- Corrosion in the electrical connector allowing current to leak to the connector shell/ground
- Damaged wiring harness where it passes through a body panel grommet or near a sharp metal edge
- Window regulator mechanical failure — cable snapped or pulley broken, motor runs but glass doesn't move
Common Fixes
- Scan vehicle with a professional-grade OBD2 scanner to read all stored codes and freeze frame data — note the conditions when the code set ($44-142 at shop, free at auto parts store for basic scan)
- Visually inspect the power window system wiring harness and connectors — look for chafed wires, melted insulation, green corrosion, loose pins, or rodent damage (often free to check yourself, $140 diagnostic fee at shop)
- Repair or replace damaged section of wiring harness where short is located — solder and heat-shrink all connections, don't use crimp connectors on critical circuits ($176-407 depending on accessibility)
- If window motor/regulator is internally shorted, replace with a quality OEM or OEM-equivalent aftermarket unit ($100-500)
- Clean all ground points related to the power window system — remove bolt, sand contact surface to bare metal, apply dielectric grease, and torque to spec ($69-154 at shop)
Estimated Repair Cost
These are estimated costs based on generic repair data. Actual costs may vary depending on your vehicle, location, and labor rates.
Frequently Asked Questions
What does B2195 mean?
B2195 stands for "Driver Window Up / Down Power Circuit Short to Ground". B2195 usually means driver Window Up / Down Power Circuit Short to Ground.
Can you drive with B2195?
Safe to drive — this is an informational or minor issue. Schedule diagnosis at your convenience.
How much does it cost to fix B2195?
Repair costs for B2195 typically range from $120 to $600, depending on your vehicle make, model, and local labor rates. Common fixes include: Scan vehicle with a professional-grade OBD2 scanner to read all stored codes and freeze frame data — note the conditions when the code set ($44-142 at shop, free at auto parts store for basic scan); Visually inspect the power window system wiring harness and connectors — look for chafed wires, melted insulation, green corrosion, loose pins, or rodent damage (often free to check yourself, $140 diagnostic fee at shop); Repair or replace damaged section of wiring harness where short is located — solder and heat-shrink all connections, don't use crimp connectors on critical circuits ($176-407 depending on accessibility).
Will B2195 clear itself?
Related Repair Costs
Explore Repair Costs
Related OBD-II Codes
These codes are in the same range as B2195 and often share similar causes and fixes.
Worried about repair costs?
Get transparent estimates and verify your mechanic's quote before authorizing repairs.
Related Discussions
See what other car owners are saying about this code and related repairs.
View B2195 discussions in the community