B2564
Low Severity (Level 2)Aux A/C Blower Speed 2 Circuit Short to Ground
B2564 usually means aux A/C Blower Speed 2 Circuit Short to Ground.
Can you still drive with B2564?
⚠️Short-distance driving is usually OK, but have this diagnosed within a week to prevent further damage.
Typical repair cost: $60 – $1000
Severity Level 2 — Low
This code indicates a minor issue that is unlikely to cause immediate driveability problems. You can typically continue driving but should have the vehicle inspected at your earliest convenience.
Common Symptoms
- A/C or heat output inconsistent — temperature won't adjust
- Climate control blowing fuses when activated
- Blower motor not working or only working on certain speeds
- Zero voltage on the climate control / HVAC system circuit — short pulls signal to ground
Possible Causes
- Chafed or pinched wire in the climate control / HVAC system circuit — wire insulation worn through, copper touching vehicle chassis/ground
- Failed blower motor with internal short to ground — most common when the component gets wet or overheats
- Corrosion in the electrical connector allowing current to leak to the connector shell/ground
- Damaged wiring harness where it passes through a body panel grommet or near a sharp metal edge
Common Fixes
- Scan vehicle with a professional-grade OBD2 scanner to read all stored codes and freeze frame data — note the conditions when the code set ($2-126 at shop, free at auto parts store for basic scan)
- Visually inspect the climate control / HVAC system wiring harness and connectors — look for chafed wires, melted insulation, green corrosion, loose pins, or rodent damage (often free to check yourself, $74 diagnostic fee at shop)
- Repair or replace damaged section of wiring harness where short is located — solder and heat-shrink all connections, don't use crimp connectors on critical circuits ($144-320 depending on accessibility)
- If blower motor is internally shorted, replace with a quality OEM or OEM-equivalent aftermarket unit ($50-800)
- Clean all ground points related to the climate control / HVAC system — remove bolt, sand contact surface to bare metal, apply dielectric grease, and torque to spec ($58-142 at shop)
Estimated Repair Cost
These are estimated costs based on generic repair data. Actual costs may vary depending on your vehicle, location, and labor rates.
Frequently Asked Questions
What does B2564 mean?
B2564 stands for "Aux A/C Blower Speed 2 Circuit Short to Ground". B2564 usually means aux A/C Blower Speed 2 Circuit Short to Ground.
Can you drive with B2564?
Short-distance driving is usually OK, but have this diagnosed within a week to prevent further damage.
How much does it cost to fix B2564?
Repair costs for B2564 typically range from $60 to $1000, depending on your vehicle make, model, and local labor rates. Common fixes include: Scan vehicle with a professional-grade OBD2 scanner to read all stored codes and freeze frame data — note the conditions when the code set ($2-126 at shop, free at auto parts store for basic scan); Visually inspect the climate control / HVAC system wiring harness and connectors — look for chafed wires, melted insulation, green corrosion, loose pins, or rodent damage (often free to check yourself, $74 diagnostic fee at shop); Repair or replace damaged section of wiring harness where short is located — solder and heat-shrink all connections, don't use crimp connectors on critical circuits ($144-320 depending on accessibility).
Will B2564 clear itself?
Related Repair Costs
Explore Repair Costs
Related OBD-II Codes
These codes are in the same range as B2564 and often share similar causes and fixes.
Worried about repair costs?
Get transparent estimates and verify your mechanic's quote before authorizing repairs.
Related Discussions
See what other car owners are saying about this code and related repairs.
View B2564 discussions in the community