P0101

Large vacuum leaks, Split Intake Air Boot or PCV Hose, Defective intake manifold gaskets, Mass Airflow Sensor (MAF), Mass Air Flow Sensor circuit and or wiring problems, Defective Barometric Pressure Sensor, Dirty or contaminated Mass Air Flow Sensing wire or filament, PCM software needs to be updated

OBD-II diagnostic trouble code P0101indicates a fault detected by the vehicle's onboard computer. This code applies to all OBD-II compliant vehicles and should be addressed promptly to avoid potential engine or emissions system damage.

Severity Level 3 — Moderate

This code indicates a moderate issue that may affect vehicle performance and fuel economy. Continued driving is possible in most cases, but prompt diagnosis and repair are recommended to prevent further damage.

Common Symptoms

• Check engine light on
• Reduced fuel economy
• Possible rough idle or hesitation

Possible Causes

• Large vacuum leaks, Split Intake Air Boot or PCV Hose, Defective intake manifold gaskets, Mass Airflow Sensor (MAF), Mass Air Flow Sensor circuit and or wiring problems, Defective Barometric Pressure Sensor, Dirty or contaminated Mass Air Flow Sensing wire or filament, PCM software needs to be updated
• Manufacturer-specific condition
• Fault in related component or circuit

Common Fixes

• Diagnose with professional OBD2 scan tool
• Check manufacturer TSBs
• Inspect related components per service manual

Estimated Repair Cost

These are estimated costs based on generic repair data. Actual costs may vary depending on your vehicle, location, and labor rates.

Explore Repair Costs

Related Discussions

See what other car owners are saying about this code and related repairs.