P2E86
Low Severity (Level 2)Battery Charger B Input Voltage Sensor Circuit High
P2E86 usually means battery Charger B Input Voltage Sensor Circuit High.
Can you still drive with P2E86?
⚠️Short-distance driving is usually OK, but have this diagnosed within a week to prevent further damage.
Typical repair cost: $100 – $500
Severity Level 2 — Low
This code indicates a minor issue that is unlikely to cause immediate driveability problems. You can typically continue driving but should have the vehicle inspected at your earliest convenience.
Common Symptoms
- Electrical system reading abnormally high or staying at maximum
- Engine may run rich or have poor fuel economy (PCM sees faulty signal)
- Diagnostic trouble code (DTC) stored in module memory
- Fault may be intermittent — code may clear itself and reappear
- Reduced vehicle functionality related to the battery voltage/system voltage
Possible Causes
- Failed battery — internal short causing abnormally high voltage signal to the control module
- Wiring shorted to a 5V reference or 12V power wire in the same harness — wires melted together or chafing at a common point
- Poor ground connection for the battery voltage/system voltage — high resistance in ground path causes voltage to read high
- Faulty voltage regulator or power supply within the battery
Common Fixes
- Scan vehicle with a professional-grade OBD2 scanner to read all stored codes and freeze frame data — note the conditions when the code set ($2-91 at shop, free at auto parts store for basic scan)
- Visually inspect the battery voltage/system voltage wiring harness and connectors — look for chafed wires, melted insulation, green corrosion, loose pins, or rodent damage (often free to check yourself, $119 diagnostic fee at shop)
- Test battery with a multimeter at the connector — compare readings to factory service manual specs. If out of spec, replace battery ($100-500)
- Check the reference voltage supply to battery — should be steady 5V (or 12V) — if low, trace back to PCM/BCM voltage regulator ($149-664 if module repair needed)
- Perform a voltage drop test on the ground side of the battery voltage/system voltage circuit — more than 0.1V drop means a bad ground that must be cleaned/repaired ($75-207 at shop)
Estimated Repair Cost
These are estimated costs based on generic repair data. Actual costs may vary depending on your vehicle, location, and labor rates.
Frequently Asked Questions
What does P2E86 mean?
P2E86 stands for "Battery Charger B Input Voltage Sensor Circuit High". P2E86 usually means battery Charger B Input Voltage Sensor Circuit High.
Can you drive with P2E86?
Short-distance driving is usually OK, but have this diagnosed within a week to prevent further damage.
How much does it cost to fix P2E86?
Repair costs for P2E86 typically range from $100 to $500, depending on your vehicle make, model, and local labor rates. Common fixes include: Scan vehicle with a professional-grade OBD2 scanner to read all stored codes and freeze frame data — note the conditions when the code set ($2-91 at shop, free at auto parts store for basic scan); Visually inspect the battery voltage/system voltage wiring harness and connectors — look for chafed wires, melted insulation, green corrosion, loose pins, or rodent damage (often free to check yourself, $119 diagnostic fee at shop); Test battery with a multimeter at the connector — compare readings to factory service manual specs. If out of spec, replace battery ($100-500).
Will P2E86 clear itself?
Related Repair Costs
Explore Repair Costs
Related OBD-II Codes
These codes are in the same range as P2E86 and often share similar causes and fixes.
Worried about repair costs?
Get transparent estimates and verify your mechanic's quote before authorizing repairs.
Related Discussions
See what other car owners are saying about this code and related repairs.
View P2E86 discussions in the community