P34BF
Serious Severity (Level 4)B Camshaft Position Actuator Position Sensor A Circuit High Bank 1
P34BF usually means b Camshaft Position Actuator Position Sensor A Circuit High Bank 1.
Can you still drive with P34BF?
⚠️Limited driving — get to a repair shop within 1–2 days. Avoid long trips and highway speeds.
Typical repair cost: $50 – $400
Severity Level 4 — Serious
This code indicates a serious issue that can cause noticeable driveability problems and potential engine damage if not addressed. The vehicle should be taken to a mechanic as soon as possible. Extended driving is not recommended.
Common Symptoms
- Engine reading abnormally high or staying at maximum
- Engine may run rich or have poor fuel economy (PCM sees faulty signal)
- Check Engine Light illuminated
- Diagnostic trouble code (DTC) stored in module memory
Possible Causes
- Failed camshaft position sensor — internal short causing abnormally high voltage signal to the control module
- Wiring shorted to a 5V reference or 12V power wire in the same harness — wires melted together or chafing at a common point
- Poor ground connection for the camshaft position sensor — high resistance in ground path causes voltage to read high
- Faulty voltage regulator or power supply within the sensor
Common Fixes
- Scan vehicle with a professional-grade OBD2 scanner to read all stored codes and freeze frame data — note the conditions when the code set ($23-90 at shop, free at auto parts store for basic scan)
- Visually inspect the camshaft position sensor wiring harness and connectors — look for chafed wires, melted insulation, green corrosion, loose pins, or rodent damage (often free to check yourself, $122 diagnostic fee at shop)
- Test camshaft position sensor with a multimeter at the connector — compare readings to factory service manual specs. If out of spec, replace camshaft position sensor ($50-350)
- Check the reference voltage supply to camshaft position sensor — should be steady 5V (or 12V) — if low, trace back to PCM/BCM voltage regulator ($123-707 if module repair needed)
- Perform a voltage drop test on the ground side of the camshaft position sensor circuit — more than 0.1V drop means a bad ground that must be cleaned/repaired ($100-167 at shop)
Estimated Repair Cost
These are estimated costs based on generic repair data. Actual costs may vary depending on your vehicle, location, and labor rates.
Frequently Asked Questions
What does P34BF mean?
P34BF stands for "B Camshaft Position Actuator Position Sensor A Circuit High Bank 1". P34BF usually means b Camshaft Position Actuator Position Sensor A Circuit High Bank 1.
Can you drive with P34BF?
Limited driving — get to a repair shop within 1–2 days. Avoid long trips and highway speeds.
How much does it cost to fix P34BF?
Repair costs for P34BF typically range from $50 to $400, depending on your vehicle make, model, and local labor rates. Common fixes include: Scan vehicle with a professional-grade OBD2 scanner to read all stored codes and freeze frame data — note the conditions when the code set ($23-90 at shop, free at auto parts store for basic scan); Visually inspect the camshaft position sensor wiring harness and connectors — look for chafed wires, melted insulation, green corrosion, loose pins, or rodent damage (often free to check yourself, $122 diagnostic fee at shop); Test camshaft position sensor with a multimeter at the connector — compare readings to factory service manual specs. If out of spec, replace camshaft position sensor ($50-350).
Will P34BF clear itself?
Related Repair Costs
Explore Repair Costs
Related OBD-II Codes
These codes are in the same range as P34BF and often share similar causes and fixes.
Worried about repair costs?
Get transparent estimates and verify your mechanic's quote before authorizing repairs.
Related Discussions
See what other car owners are saying about this code and related repairs.
View P34BF discussions in the community